1954-62 Cadillac Spark Plug Wire Separator (4-Hole) by Steele Rubber Products®
Dense EPDM and the original oblong profile support four ignition leads in the factory arrangement.
This dense-EPDM reproduction matches the original oblong spark-plug-wire spacer and its four wire holes. The rubber body separates and supports the ignition leads while matching the original push-on installation. It is manufactured in the USA and corresponds to GM® reference 1458862. Dimensions and the four-hole arrangement should be matched to the existing spacer position.
• 1954-62 Cadillac (See full fitment list below)
• Four-hole oblong reproduction wire spacer
• Dense EPDM rubber; original push-on installation
• 2-5/8 inches long and 5/8 inch thick
• Manufactured in the USA; GM® reference 1458862
Notes
- 1954-56 requires four per car, while, 1957-62 requires two per car.
WARNING: This product can expose you to chemicals including lead, sulfur, nickel, chromium, vanadium, titanium, polyvinyl chloride, and 4,4’-methylenebis (2-chloroaniline), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
