Distributor Set, Lokar, LS, w/ Plug Wires, Black Finish

GM LS Distributor Simulator and Plug-Wire Kit (Black) by Lokar®

A pass-through distributor-style housing conceals LS wire routing for a traditional engine appearance.

This Lokar® LS Classic kit gives an LS engine the appearance of a traditional distributor while retaining its coil-based ignition. The black cast-aluminum housing is a pass-through wire-routing simulator, not a functioning distributor or a conversion to one ignition coil. The included long aramid-fiber spiral-core plug wires route through the housing to the engine's ignition connections and require final sizing and termination. Installation requires the compatible LS Classic valley-pan arrangement and adequate rear-engine/firewall clearance. A ribbed valley pan or an interfering oil-pressure-sender boss can prevent installation.

• GM LS engines with a compatible LS Classic installation (See full fitment list below) • Black cast-aluminum simulator housing; no ignition distributor mechanism • Retains LS coil-based ignition rather than converting to a single coil • 7mm aramid-fiber spiral-core plug wires; 9-foot leads for routing and trimming • High-temperature silicone insulation and boots; 40-ohms/ft conductor specification • Preinstalled 90-degree coil boots; straight unterminated plug boots and 90-degree distributor boots • Cut-to-length assembly; plug-wire crimping tool required • Distributor-style housing, cap, leads, boots, terminals and mounting fasteners included • Compatible two-bolt LS Classic valley pan and rear-engine clearance required