As seen on
ADDED TO YOUR CART!
Ignition Coil, MSD, Blaster 2
ADDED TO YOUR WISHLIST!
This MSD® Blaster 2 coil uses a 100:1 winding and low-resistance primary to support high ignition output. Oil filling cools and supports the windings, while the high-dielectric alkyd tower helps resist carbon tracking. The red canister fits most matching original coil brackets and should be installed upright. It works with compatible electronic or MSD 6/7-series ignition controls; points ignition requires the specified ballast resistance. The coil wire and mounting bracket are not included.
• Compatible MSD 6/7-series, electronic or points ignition; match system requirements • 45,000-volt maximum output; 0.7-ohm primary resistance • 100:1 winding ratio; high-dielectric alkyd tower • Red oil-filled canister; upright mounting recommended • Points ignition requires appropriate ballast resistance • Coil wire, mounting bracket and mounting hardware not included
CARB EO Number: D-40-37 (pdf)
Find parts that fit your vehicle