Fastener Set, Master Interior, 1968 CHEVELLE, COUPE

1968 Chevrolet Chevelle Coupe Master Interior Fastener Kit

396-piece kit groups factory-style interior hardware in installation-labeled packets.

This 1968 Chevrolet Chevelle coupe master interior fastener kit supplies 396 hardware items in installation-labeled packets. Screws, nuts, washers, clips and retainers are matched to their original fastening applications, with factory-style screw heads and thread forms. The packet labels identify the fastening application and factory assembly-manual reference, helping distinguish hardware that may look similar but belongs in different locations. The kit goes beyond exposed trim screws: door-panel clips and flexible plugs, rubber glove-box and console bumpers, stamped trim nuts, seat-pivot retainers and floor-attachment hardware are included. The 1968 dash groups address the instrument bezel and cluster, dash pad, above-glove-box moldings/emblem, heater controls and glove-box liner/A/C shield. Coupe-specific groups cover the headliner tack strips, pillars, quarter trim and sail panels. Separate seat groups cover back and side panels, pivot covers, stops and tracks, with bench-seat release/belt-bezel and shoulder-harness retainer applications identified separately. Console, radio, lighting, sill plates, steering-wheel shroud, column covers, mirror/visor supports and window-crank hardware complete the installation coverage. Use the packet that matches the car's original equipment; console, seat, climate-control and transmission fasteners do not all serve the same configuration. This is a hardware kit, not a package of door panels, seats, console assemblies or other interior trim.

• 396 total hardware items in the kit • Factory-style screw heads, threads and fastening hardware • Application-labeled packets with factory assembly-manual references • Door trim: front/rear armrest screws, handle wire retainers and panel clips, flexible plugs and screws • Console: floor, door/hinge and end-cover screws, molding nuts and rubber door bumpers • Dashboard: dash-pad screws/nuts, A/C outlet-bezel hardware and ashtray-retainer fasteners • Instruments: bezel-to-dash and cluster-to-bezel screws; above-glove-box molding/emblem nuts where equipped • Glove box: rubber bumpers, door/liner hardware, A/C shield hardware and striker fasteners • Climate controls: heater-control/support fasteners and LH heater/A/C outlet screws • Lighting and controls: courtesy-lamp hardware, dome-lamp screws and dimmer-switch screws • Firewall: sealed fuse-panel attachment screws • Kick panels: separate A/C and Non-A/C fastening groups • Coupe upper trim: front/side/rear headliner tack-strip screws and pillar-molding screws • Rear trim: lower rear-window escutcheon screws, quarter-panel screws and sail-panel clips • Radio and sills: thin shaft nuts/spring washers and stainless/chrome scuff-plate screws • Seats: front stops, rear attachment, seat-back/side-panel screws, pivot clips and pivot-cover retainers • Bench-seat details: seat-back striker, release-bezel and seat-belt bezel fasteners • Seat-belt trim: buckle/shoulder-harness retainer hardware; not replacement belt assemblies • Seat tracks: floor fasteners with conical-tooth washers and locking nuts • Steering column: dash, cover-to-dash, cover-to-firewall and seal-retainer fasteners • Steering-wheel trim: shroud screws and shroud-emblem nuts • Mirror and visors: mirror shoulder screw/bushing, coupe support screws and clamp screws • Window hardware: vent-crank clips, door-window crank clips and quarter-glass weatherstrip screws • Turn-signal control: lever retaining screw • Equipment-specific packets identify the applicable installation • Hardware only; interior trim and assemblies are not included