Fastener Set, Master Interior, 1967 CHEVELLE, CONVERTIBLE

1967 Chevrolet Chevelle Convertible Master Interior Fastener Kit

Factory-style interior hardware is grouped by installation location in labeled packets.

This 1967 Chevrolet Chevelle convertible master interior fastener kit supplies factory-style interior hardware in installation-labeled packets. Screws, nuts, washers, clips and retainers are matched to their original fastening applications, with factory-style screw heads and thread forms. The packet labels identify the fastening application and factory assembly-manual reference, helping distinguish hardware that may look similar but belongs in different locations. Convertible hardware addresses the door-jamb wedges, windshield-header molding, quarter-trim panels and the filler panel behind the rear seat. The door-panel groups include clips and flexible plugs as well as screws. Dash and console coverage extends to the instrument trim, ashtray, dash pad, heater controls, glove-box fittings, console floor attachment, top, door/hinge, latch and lamp lens. Seat groups cover the back and side panels, pivot retainers, stops and floor attachments, with separate bench-seat release, striker and belt-bezel applications. The remaining fastening areas include the radio, underdash lighting, scuff plates, steering-column cover/seal, convertible visor brackets, vent channels, windlace ends and quarter-glass weatherstrip. Use the packet that matches the car's original equipment; console, seat, climate-control and transmission fasteners do not all serve the same configuration. This is a hardware kit, not a package of door panels, seats, console assemblies or other interior trim.

• Factory-style screw heads, threads and fastening hardware • Application-labeled packets with factory assembly-manual references • Door trim: front armrest screws, inside-handle wire retainers and panel clips, flexible plugs and screws • Convertible fittings: door-jamb wedge screws and rear-seat filler-panel screws • Convertible trim: header-molding screws, quarter-panel fasteners and door/quarter top-molding screws • Dash fittings: ashtray-retainer hardware, dash-pad fasteners and dimmer-switch screws • Instruments: instrument-trim and bezel fasteners for the appropriate dash configuration • Glove box: rubber bumpers and door, liner and striker screws • Heater controls: control/support fasteners and LH heater/A/C outlet screws • Firewall and footwell: sealed fuse-panel screws, rubber insulation retainers and Non-A/C kick-panel screws • Console: floor, top, door/hinge, latch and lamp-lens fasteners plus rubber bumpers • Lighting and radio: underdash courtesy-lamp hardware, control-shaft nuts and washers • Seats: front seat-back stops, rear seat attachment, back/side-panel screws and pivot retainers • Bench-seat details: striker, release-bezel and seat-belt bezel fasteners where used • Seat trim and tracks: release-escutcheon, buckle-retainer and floor-mounting hardware • Steering column: dash fasteners, cover-to-firewall fasteners and seal-retainer hardware • Mirror and visors: mirror shoulder screw/bushing, convertible support screws and clamp screws • Door openings: scuff-plate screws and quarter windlace end-cap screws • Window hardware: vent-channel screws, quarter-glass weatherstrip screws and crank retaining clips • Turn-signal control: lever retaining screw • Equipment-specific packets identify the applicable installation • Hardware only; interior trim and assemblies are not included