Roll/Control Front-Brake Holding Kit by Hurst®
Electric hydraulic valve holds the applied front-brake pressure for controlled staging or burnouts.
This Hurst® Roll/Control kit uses a 12-volt electrically operated valve to hold applied front-brake pressure during staging or tire warm-up. The stainless-steel valve assembly has a finned aluminum housing, an epoxy-encapsulated coil and 150-micron screened ports; an extra port accommodates a bleeder or pressure gauge. The kit includes the activation switch, indicator light, four-amp fuse, mounting screws and instructions. Brake-line fittings and routing must be matched to the vehicle. Use only for brief operation within the manufacturer's 60-second limit; it is not a parking brake or a replacement for normal braking.
• 12-volt electrically operated hydraulic holding valve
• Stainless-steel valve with finned aluminum housing
• Epoxy-encapsulated coil and 150-micron screened ports
• Extra port for a bleeder or pressure gauge
• Switch, indicator light, 4-amp fuse and mounting screws included
• Maximum 60-second operation; not a parking brake
Notes
- This item is not eligible for any further discounts or promotional pricing.
WARNING: This product can expose you to chemicals including lead, sulfur, nickel, chromium, vanadium, titanium, polyvinyl chloride, and 4,4’-methylenebis (2-chloroaniline), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
