1967 Chevelle/El Camino Front and Rear Disc Brake Kit with Booster (11" Rotors, Stock-Height Spindles) by CPP®
Plain 11-inch rotors, stock-height front spindles and power-assist components
Convert the front and rear brakes on your 1967 Chevelle and El Camino with this CPP power disc brake package. The front assembly uses stock-height spindles, 11-inch plain vented rotors and loaded single-piston calipers, with mounting brackets, bearings, seals, hoses and hardware. The rear conversion supplies two 11-inch plain vented rotors, single-piston calipers, mounting brackets, rubber hoses, rear axle hard lines, parking-brake cables and installation hardware. The rear assembly is intended for the matching factory 10- or 12-bolt rear axle; verify the axle before ordering. A vacuum booster, cast-iron master cylinder, proportioning valve and front hard lines complete the hydraulic package. This 1967 configuration uses an 11-inch booster; select the correct engine option for hard-line routing. The bolt pattern is 5 x 4.75 inches. These kits require disc-brake-compatible wheels at least 15 inches in diameter; verify wheel profile and brake clearance.
• Front and rear rotors: 11-inch plain vented
• Front spindle height: stock
• Calipers: single piston
• Rear brake hoses: rubber
• Rear parking-brake cables and axle hard lines: included
• Rear axle: matching factory 10- or 12-bolt configuration
• Wheel bolt pattern: 5 x 4.75 inches
• Minimum wheel diameter: 15 inches; verify clearance
WARNING: This product can expose you to chemicals including lead, sulfur, nickel, chromium, vanadium, titanium, polyvinyl chloride, and 4,4’-methylenebis (2-chloroaniline), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
