1968-72 GM A-Body Front Disc Brake Kit with Booster (11" Rotors, 2" Drop Spindles, OE-Style, Deluxe) by CPP®
Dimple-drilled and slotted rotors, braided stainless steel hoses and 11-inch booster
Convert the front brakes on your 1968–1972 GM A-Body with this CPP kit. It pairs 2-inch-drop ductile-iron spindles with two 11-inch vented, dimple-drilled and slotted rotors and natural-finish, single-piston cast-iron calipers with pads. The wheel-end package includes caliper mounting brackets, dust shields, inner and outer wheel bearings, grease seals, braided stainless steel brake hoses and mounting hardware. Power-assist components include a 11-inch Delco-stamped OE-style vacuum booster, a cast-iron master cylinder, proportioning valve, mounting hardware and front brake hard lines. The rotor dimples do not pass through the disc; this is the intended dimple-drilled design. The spindles lower the front of the vehicle 2 inches. The wheel bolt pattern is 5 x 4.75 inches. Use disc-brake-compatible wheels at least 15 inches in diameter and verify caliper, wheel and tire clearance before installation.
• Application: 1968–1972 GM A-Body; see vehicle fitment
• Front rotors: 11-inch vented, dimple-drilled and slotted
• Spindles: 2-inch-drop, ductile iron
• Calipers: natural-finish cast iron, one piston per caliper
• Front hoses: braided stainless steel
• Wheel bolt pattern: 5 x 4.75 inches
• Power assist: 11-inch Delco-stamped OE-style vacuum booster
• Minimum wheel diameter: 15 inches; wheel profile must clear brakes
WARNING: This product can expose you to chemicals including lead, sulfur, nickel, chromium, vanadium, titanium, polyvinyl chloride, and 4,4’-methylenebis (2-chloroaniline), which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
