Selecting your vehicle's model and year allows us to display only parts and items specific to your car's model and year.
Be the First to Review
Part ID: L240772-LH
Part ID: L240772-RH
Part ID: L240772-PR
Part Type: (R) = Authentic reproduction of the original GM product
Sold As: EACH
2017 Late Monte Carlo Catalog Page: 882018 Late Monte Carlo Catalog Page: 92
Products that require truck freight delivery are items too large to be shipped via FedEx Ground. These are items such as fenders, hoods, etc. All truck freight orders must be prepaid. Rates begin at $120.00 and vary based on weight. Please contact our customer service department for accurate freight charges or visit our website at
These door shells are manufactured to factory specs for an excellent fit. Door shells are ready to install. The stamped steel construction features both an inner and outer structure as well as all properly located holes for door handle, latch, hinges and locks. All door shells are EDP-coated for protection.
Regarding Minor Imperfections In Panels:
The sheet metal you receive may have scratches, dings, small dents and other minor imperfections, which are considered normal sheet metal characteristics due to the nature of the product. OPGI does not consider these minor imperfections as damaged. These items will be easily corrected during the filling, priming and sanding phase of your sheet metal installation. All sheet metal panels will require some sort of manipulation during installation. Every panel that we sell is inspected and then carefully packaged to protect against damage that may occur during transit.
Test Fit All Panels Prior To Paint and Installation:
OPGI recommends test fitting all sheet metal panels prior to final paint and installation. It is also recommended that the damaged area of the vehicle not to be cut out before receiving the new sheet metal. Measure twice, cut once to be safe. Sheet metal panels are not a finished product like door handles & mirrors. Minor modifications including elongating mounting holes, adding shims etc. are normal and may be necessary when installing sheet metal. This is a consideration when reinstalling original GM panels as well as reproductions. It is important to note that hard driving conditions can twist frames and bodies out of original tolerances. Poor body work from previous collisions can cause problems with the body structures that the panels are attached to.