Original Parts Group Logo
US & Canada Phone Number 1-800-243-8355
International Phone Number 1-562-594-1000
 El Camino Free Shipping on Orders Over $99 Promotion Banner
Part fits the following years:1968, 1969, 1970, 1971, 1972

RESTOPARTS

Quarter Panels, 1968-72 El Camino 89" Long X 29" High

 

4 Reviews

Part Type: (R) = Authentic reproduction of the original GM product
Years: Sold As: EACH
2017 El Camino Catalog Page: 275
2018 El Camino Catalog Page: 267


’68-72 El Camino

One-piece stamping is identical in contour, fit and finish

  • NOTES
  • SHIP NOTE: This item cannot be shipped FedEx Ground and requires Truck Freight Delivery which must be prepaid by credit or check (no C.O.D). Please call or email us for an exact quote. more info

Dimensionally, these panels run from approximately 1" behind the door to the rear tail lights. They run completely down below from the rear end to the lower section in front of the wheel well, as shown. These panels do not extend to the upper roofline, but only to the belt seam.

Regarding Minor Imperfections In Steel Panels: The sheet metal you receive may have scratches, dings, small dents and other minor imperfections, which are considered normal sheet metal characteristics due to the nature of the product. OPGI does not consider these minor imperfections as damaged. These items will be easily corrected during the filling, priming and sanding phase of your sheet metal installation. All sheet metal panels will require some sort of manipulation during installation. Every panel that we sell is inspected and then carefully packaged to protect against damage that may occur during transit. Test Fit All Panels Prior To Paint and Installation: OPGI recommends test-fitting all sheet metal panels prior to final paint and installation. It is also recommended that the damaged area of the vehicle not be cut out before receiving the new sheet metal. Measure twice, cut once to be safe. Sheet metal panels are not a finished product like door handles and mirrors. Minor modifications including elongating mounting holes, adding shims etc. are normal and may be necessary when installing sheet metal. This is a consideration when reinstalling original GM panels as well as reproductions. It is important to note that hard driving conditions can twist frames and bodies out of original tolerances. Poor bodywork from previous collisions can cause problems with the body structures that the panels are attached to.

Point Coins Earn 236 points more info
Switch to Mobile Site »

Original Parts Group

Special Deals!
Never Miss A Promotion
×
If you see this, please contact your IT department and ask them to unblock www.opgi-static.com