1968-72 Rocker Panel, Below Door (Steel) Outer, 2-dr. Chevelle

’64-77 Chevelle and El Camino

Available for inner and outer applications

• NOTES
• SHIP NOTE: This item exceeds standard size and is exempt from free shipping. 

  Items Exempt from Free Shipping

  Certain items which exceed standard size are exempt from free shipping promotions. These items are noted in your cart at checkout.

• SHIP NOTE: This item as packaged measures over 48" in length, and/or 30" in width or height and is subject to an additional handling surcharge of $15.95. 

  Additional Handling Surcharges

  Any package that measures over 48” in length, and/or 30” in width or height, is subject to an additional handling surcharge of $15.95 per package. Unusually shaped packages such as cylinders or drums are also subject to this charge, as are unusual exterior packaging materials such as plastic or cloth.

These authentically reproduced, steel lower body rocker panels from OPGI are each precisely stamped to factory specifications for an excellent fit and finish. Panels are available for inner or outer rockers and sold per each for left or right hand sides, or as a pair.

Regarding Minor Imperfections In Panels: The sheet metal you receive may have scratches, dings, small dents and other minor imperfections, which are considered normal sheet metal characteristics due to the nature of the product. OPGI does not consider these minor imperfections as damaged. These items will be easily corrected during the filling, priming and sanding phase of your sheet metal installation. All sheet metal panels will require some sort of manipulation during installation. Every panel that we sell is inspected and then carefully packaged to protect against damage that may occur during transit. Test Fit All Panels Prior To Paint and Installation: OPGI recommends test fitting all sheet metal panels prior to final paint and installation. It is also recommended that the damaged area of the vehicle not to be cut out before receiving the new sheet metal. Measure twice, cut once to be safe. Sheet metal panels are not a finished product like door handles & mirrors. Minor modifications including elongating mounting holes, adding shims etc. are normal and may be necessary when installing sheet metal. This is a consideration when reinstalling original GM panels as well as reproductions. It is important to note that hard driving conditions can twist frames and bodies out of original tolerances. Poor body work from previous collisions can cause problems with the body structures that the panels are attached to.