Original Parts Group Logo
US & Canada Phone Number 1-800-243-8355
International Phone Number 1-562-594-1000
 Chevelle Memorial Day Sale Promotion Banner
Part fits the following years:1970, 1971, 1972

RESTOPARTS

Quarter Panels, 1970-72 Chevelle 75" Long X 20" High

 

Be the First to Review

Part Type: (R) = Authentic reproduction of the original GM product
Years: Sold As: EACH
2018 Chevelle Catalog Page: 268


’70-72 Chevelle coupe and convertible

Professional steel stamping that includes the authentic marker lamp cut out

  • NOTES
  • SHIP NOTE: This item cannot be shipped FedEx Ground and requires Truck Freight Delivery which must be prepaid by credit or check (no C.O.D). Please call or email us for an exact quote. more info

These quarter panels are an outstanding, high-quality alternative to the more expensive GM-licensed versions available. IMPORTANT NOTE: 1" behind the door to approximately 1-1/2" in front of the rear tail lights. They run completely down below from the rear end to the lower section in front of the wheel well as shown. These panels do not extend to the upper roofline, but only to the belt seam. They may be used on a convertible or coupe.

Regarding Minor Imperfections In Steel Panels: The sheet metal you receive may have scratches, dings, small dents and other minor imperfections, which are considered normal sheet metal characteristics due to the nature of the product. OPGI does not consider these minor imperfections as damaged. These items will be easily corrected during the filling, priming and sanding phase of your sheet metal installation. All sheet metal panels will require some sort of manipulation during installation. Every panel that we sell is inspected and then carefully packaged to protect against damage that may occur during transit. Test Fit All Panels Prior To Paint and Installation: OPGI recommends test-fitting all sheet metal panels prior to final paint and installation. It is also recommended that the damaged area of the vehicle not be cut out before receiving the new sheet metal. Measure twice, cut once to be safe. Sheet metal panels are not a finished product like door handles and mirrors. Minor modifications including elongating mounting holes, adding shims etc. are normal and may be necessary when installing sheet metal. This is a consideration when reinstalling original GM panels as well as reproductions. It is important to note that hard driving conditions can twist frames and bodies out of original tolerances. Poor bodywork from previous collisions can cause problems with the body structures that the panels are attached to.

Point Coins Earn 139 points more info
Switch to Mobile Site »

Original Parts Group

Special Deals!
Never Miss A Promotion
×
If you see this, please contact your IT department and ask them to unblock www.opgi-static.com